General Safety; Electrical Safety - Hozelock 7825 Manual Del Usuario

General Safety

Warning : Read this manual carefully before
installing this pump.
This sign warns the user that failure to
follow an instruction may damage the
pump or the system
This sign warns the user of important
electrical safety information.
Carefully store this manual.
If problems arise contact
Hozelock customer services.
Every Hozelock Flood Pump
is carefully tested and packed during assembly.
On receipt, check that the pump has not been
damaged during transport. If the pump is
damaged, do not use, and contact Hozelock
customer services.

Electrical Safety

Check that the voltage and frequency of pump
shown on the rating label corresponds to those
available on the mains.
ELECTRICAL INSTALLATION:
A 10MA OR 30MA RESIDUAL CURRENT
DEVICE (RCD) MUST BE FITTED TO THE
MAINS SUPPLY.
PROTECT THE PLUG AND THE POWER
CABLE FROM HEAT,
OIL AND SHARP EDGES.
DO NOT OPERATE THE PUMP IF IT HAS A
DAMAGED POWER CORD OR PLUG. IF THE
POWER CORD OR PLUG IS DAMAGED, IT
MUST BE REPLACED BY A SUITABLY
QUALIFIED PERSON IN ORDER TO AVOID A
HAZARD.
MAKE SURE THAT ELECTRIC CONNECTIONS
ARE PROTECTED FROM WATER & SPLASHES
THE POWER CABLE SHOULD HAVE A
MINIMUM OF 3 CORE 0.75MM
EQUIVALENT TO THAT OF H05 RN-F. TO
MAKE SURE THE PLUG IS PROTECTED
FROM ANY SPLASHES, USE THE 10M CABLE
SUPPLIED TO CONNECT AS FAR AWAY
FROM THE PUMP AS POSSIBLE
BEFORE USING THE PUMP, ALWAYS
INSPECT IT VISUALLY (ESPECIALLY THE
POWER CABLE AND THE PLUG). DO NOT
The pump can be completely or partially
submersed and used to transfer clean or dirty
fluids.
2
SECTION
USE THE PUMP IF IT IS DAMAGED.
NEVER USE THE POWER CABLE TO LIFT THE
PUMP.
Limitations
This pump should not be used with
swimming pools where people can become
immersed in water.
This pump shouldnot be used for table
fountains / aquariums / fountains / filters
for fish ponds / waterfalls.
If aquatic wildlife eg fish or frogs could be
present in the water, you must take the
required measure to prevent them being
sucked into the pump.
The pump cannot be used for sea water &
inflammable, corrosive, explosive or
dangerous liquids.
The pump must never run dry.
The pump can handle max solids of 30mm.
However this will be reduced by the
diameter of the hose. eg 25mm hose may
block if solids greater than 25mm are
present.
When set up for automatic operation the
pump will turn on at a water depth of
400mm, and turn off at a water depth of
190mm (Fig 1).
The pump must not be used when people
are in the water.
The sprayer must not be used when people
are in the water.
Do not spray the outlet towards people or
animals.
This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities, or
lack of experience and knowledge, unless
they have been given supervision or
instruction concerning use of the appliance
by a person responsible for their safety.
Installation
Before installation, and whenever you are