Hozelock 7825 Manual Del Usuario página 5

handling the pump, always disconnect from the
electrical supply.
To prevent injury, never put your fingers into the
mouth of the pump.
• Use the handle provided to carry or lift the
pump (see Fig 2).
• To maximise pump performance always use
either 25mm or 32mm hose with this pump.
• Cut the hose tail to match the diameter of the
hose selected.
25mm (no cut required),
32mm (cut as indicated Fig 3).
• Screw the threaded fitting supplied onto the
pump (Fig. 4).
• To connect the pump to a hose, push over the
inlet and secure with a rust proof hose clip (not
supplied). Ensure that the hose is not kinked
and free to drain to waste. Pump performance
depends upon hose length, hose diameter and
discharge height.
NEVER use ⁄ " (12.5mm garden hose).
1
2
• The flood pump is fitted with an automatic
float switch. This turns the pump on/off
automatically as the water level rises. For
correct operation it needs a minimum of 50cm
in all directions to prevent the float switch
jamming on the container (Fig 5).
Overload Protection
• The Hozelock Flood Pump has
a built in thermal protection switch.
The pump stops if an overload condition occurs.
The motor restarts automatically after it has
cooled down.
To start the pump
• Insert the plug into a 220-240v A/C socket (Fig
6).
• To use the pump manually the float switch
should be supported. In manual mode the
pump will pump down to a minimum depth of
70mm.
• To ensure correct automatic operation, the float
switch should be clipped into the pump housing
as indicated (Fig 7).
Maintenance
In ordinary conditions the Flood Pump does not
require any maintenance, however occasionally it
will be necessary to clean the inlet (see Figs 8 & 9).
Make sure that the pump is disconnected
from the electric power supply before
performing any maintenance (Fig 6).
• Stage 1 Cleaning :
Remove the 3 screws on the base plate and
remove any visible debris (Fig 8).
• Stage 2 Cleaning :
Remove a further 6 screws and remove debris
within the pump chamber (Fig 9).
• Then re-assemble.
Pump storage
• Store the pump in a dry place and protect from
frost.
Contact details
Hozelock Limited
Midpoint Park, Birmingham. B76 1AB
Tel : +44 (0) 121 313 1122
Internet : www.hozelock.com
Email : info@hozelock.com