Hammerhead HLCL01 Manual Del Usuario página 8

OPERATION
3. LASER LINE PROJECTION MODES
Your compact self-leveling cross line
laser has three laser-projection modes. To
select a specific laser-projection mode,
press the mode button until you reach the
desired projection mode. This laser tool
defaults to the cross-hair pattern mode
when it is turned on.
To choose a projection mode, press the
mode button:
a. Press the button once to select the
horizontal laser line.
b. Press the button twice to select
the vertical laser line.
c. Press the button three times to return to the cross-hair pattern (both horizontal and
vertical lines).
4. SELF-LEVELING MODE
Your compact self-leveling cross line
laser has two working modes: self-
leveling mode and lock (manual) mode. In
self-leveling mode, the tool will level itself
if it is within ±4° of horizontal.
a. Place the compact self-leveling
cross line laser on a flat, smooth
surface that is within ±4° of
horizontal.
b. Turn the tool on by sliding the
power switch in the direction of
the "ON" arrow. The compact
self-leveling cross line laser will
automatically level within 6 seconds. The LED indicator will illuminate in green.
c. Press the mode button until the desired laser-projection mode is achieved and the
laser line is projected from the laser aperture.
d. If the surface on which the compact self-leveling cross line laser is placed exceeds
±4° from horizontal, the laser line will blink as an alarm and the LED indicator will
turn to red. In this event, adjust the angle of the surface slightly.
e. To turn off the laser lines, slide the switch in the direction of the "OFF" arrow.
8
3
MODE
BUTTON
4
COMPACT SELF-LEVELING CROSS LINE LASER WITH CLAMP