Special Function - Honeywell Home FocusPRO 5000 Serie Instrucciones Para La Instalación

Setup function
Shaded areas below apply only to
7 Auxiliary heat
cycle rate (CPH)*
Only TH5320U
for 3H/2C Heat
Pumps
9 Stage 1 compressor
cycle rate (CPH)
10 Stage 2 compressor
cycle rate (CPH)
12 Manual/Auto
changeover
14 Temperature
display
15 Compressor
protection
26 Auxiliary heat
control
27 Heat temperature
range stops
28 Cool temperature
range stops

Special function

Auxiliary heat control (Setup Function 26):
Comfort Setting: The thermostat will prioritize comfort over economy
depending on heat pump performance, load conditions and whether the
thermostat is calling for the heat pump. Raising the temperature just a few
degrees will often activate the auxiliary heat.
Economy Setting: The thermostat will attempt to reach the temperature
setting without activating the auxiliary heat. The thermostat will wait to
activate the auxiliary heat depending on heat pump performance, load
conditions and how many degrees the temperature setting is changed.
Settings & options (factory default in bold)
TH5320U/TH5220D
5 For gas or oil furnaces of less than 90% efficiency
1 For steam or gravity systems
3 For hot water systems & furnaces of over 90% efficiency
9 For electric furnaces
3 Recommended for most compressors
[Other cycle rate options: 1, 2, 4, 5 or 6 CPH]
3 Recommended for most compressors
[Other cycle rate options: 1, 2, 4, 5 or 6 CPH]
0 Manual changeover (Heat/Cool/Off)
1 Auto changeover (Heat/Cool/Auto/Off)
2 Auto changeover only (Auto)
0 Fahrenheit
1 Celsius
5 Five-minute compressor off time
[Other options: 0, 1, 2, 3 or 4-minute off time]
0 Comfort
1 Economy
90 Max. heat temperature setting is 90 °F (32 °C)
[Other options: 40 °F to 89 °F (4.5 °C to 31.5 °C)]
50 Min. cool temperature setting is 50 °F (10 °C)
[Other options: 51 °F to 99 °F (10.5 °C to 37 °C)]
6
or as otherwise noted.