Chicco Rodeo Manual De Instrucciones página 10

The first operation that should be carried out is the fitting of the batteries as indicated below:
FITTING AND/OR REPLACING BATTERIES
Fit 3 x "AA" 1.5 Volt alkaline type batteries into the battery compartment located inside the head of toy,
following the warnings indicated below:
• Batteries must only be fitted by an adult.
• To replace spent batteries: Loosen the screw on the battery compartment cover with a screwdriver
and remove the cover. Then remove the spent batteries and fit new ones, ensuring that they have
been fitted in the correct polarity (as shown on the product), close the battery cover, and tighten the
screw.
• Only use alkaline batteries of the same type or equivalent to the type recommended for the correct
function of this product.
• Never mix new and old or different types of batteries.
• Always keep batteries and tools out of reach of children.
• Do not short-circuit the battery terminals.
• Always remove spent batteries from the toy to avoid the danger of leakage from the battery damag-
ing the product.
• Always remove the batteries if the toy will not be used for a long period of time.
• Remove the batteries from the toy before disposal.
• Do not burn or dispose of spent batteries into the environment. Dispose of them at an appropriate
differentiated collection point.
• In the case of battery leakage, replace them immediately and clean the battery compartment care-
fully. Wash hands thoroughly if they come into contact with the leaked fluid.
• Do not attempt to recharge non-rechargeable batteries, they might explode.
• The use of rechargeable batteries is not recommended, since they might impair the toy's functional-
ity.
• If rechargeable batteries are used, remove them from the toy before recharging; this operation must
be carried out only under adult supervision.
This product complies with the Directive 2012/19/EU.
The crossed bin symbol on the appliance indicates that the product, at the end of its life,
must be disposed of separately from domestic waste, either by taking it to a separate waste
disposal site for electric and electronic appliances or by returning it to your dealer when you
buy another similar appliance. The user is responsible for taking the appliance to a special
waste disposal site at the end of its life. If the disused appliance is collected correctly as separate wa-
ste, it can be recycled, treated and disposed of ecologically; this avoids a negative impact on both the
environment and health, and contributes towards the recycling of the product's materials. For further
information regarding the waste disposal services available, contact your local waste disposal agency
or the shop where you bought the appliance.
HOW TO ASSEMBLE THE TOY
Diag. 1
Assemble the head, placing it on top of the body and tightening the 4 screws supplied. Ensure the
screws are tightened firmly and safely into position.
Diag. 2
Place the "foulard", as shown in the diagram, and block it with the clip.
Diagrams 3,4,5
10