Publicidad
Idiomas disponibles
Idiomas disponibles
Use existing hole in
the frame
Use second hole as
shown
Note:
typical
Fasteners
, both sides
1
Qty. (4)
Carriage Bolt 1/2-13 X 2.00
2
2
Qty. (2)
Qt
(2)
Block 25 X 1 00 X 2 00
Block .25 X 1.00 X 2.00
3
Qty. (8)
Lock Washer 1/2"
MODELS WITH 56" BED USE THIS DIAGRAM (See page one for models with 75" bed.)
1. Remove the bolt from the bottom of the frame on both sides of the vehicle. Insert 1/2" carriage bolt and
large bolt plate through large rear hole in the frame. Bolt leaders may be used to assist installation. Repeat for the other side.
2. Lift the hitch up to the frame with the carriage bolts going down through the second hole from rear in the
hitch bracket. Install 1/2" lock washers and 1/2" nuts on the bolts. See the diagram above.
3. Using the front hole in the bracket as a guide, drill a 1/2" hole in the frame. Insert a 1/2" carriage bolt
with a small bolt plate down through the frame and the hitch bracket. Bolt leaders may be used to assist installation
Install a 1/2" lock washer and 1/2" nut on the bolt. Repeat for the other side. See the diagram above.
NOTE: The above installation can be used for models with 75" beds, but longer ball mounts and
weight distributing shanks will be required.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z
2002, 2003, 2004, 2006, 2008, 2009, 2011 Cequent Performance Products
Installation Instructions
Nissan Pick-Up
1
2
1
5
5
3
4
Tighten all 1/2" fasteners with torque wrench to 75 Lb.-Ft. (102 N*M)
1
5
4
Qty. (8)
Hex Nut 1/2-13
5
5
Qty. (2)
Qt
(2)
Block .25 X 1.500 X 3.00
Block 25 X 1 500 X 3 00
Qty. (4)
Bolt Leader
Sheet 2 of 6
N75186
Part Numbers:
75186
44148
87491
78273
U-HAUL
1
2
Frame
Use forward hole as
a guide to drill 1/2"
hole in frame
3
3
4
4-18-11
Rev. K
Form: F205 Rev A 5-6-05
Publicidad
