Publicidad
Idiomas disponibles
Idiomas disponibles
www.jts-europe.com
These instructions are intended
ENGLISH
for users without any specific
technical
knowledge.
read the instructions carefully
prior to operation and keep
them for later reference.
1 Applications
The desktop microphone ST-5000T is designed
for conferences and announcements. It fea-
tures a high-quality condenser microphone
cartridge with a gold-plated 12.5 mm (½")
diaphragm. The microphone provides an on-off
switch and an LED power indicator. If required,
it is possible to attenuate the signal level and to
activate a high pass filter (impact sound filter).
The microphone uses phantom power
(36 – 52 V) which is available at the micro-
phone input of many mixing consoles and
preamplifiers.
2 Important Notes
The product corresponds to all relevant direc-
tives of the EU and is therefore marked with
•
The product is suitable for indoor use only.
Protect it against dripping water, splash
water and high air humidity. The admissible
ambient temperature range is 0 – 40 °C.
•
For cleaning the product only use a dry, soft
cloth; never use water or chemicals.
•
No guarantee claims for the product and no
liability for any resulting personal damage
or material damage will be accepted if the
product is not correctly used or not expertly
repaired.
If the product is to be put out of oper-
ation definitely, dispose of the product
in accordance with local regulations.
3 Before Operation
Before connecting / disconnecting, mute the
microphone input or turn down the volume of
the corresponding device (e. g. mixing console
or amplifier).
Use an XLR cable to connect the output (1) of
the microphone to the microphone input of
the subsequent device. The input must provide
phantom power (36 – 52 V); if it does not, con-
nect the microphone to the input via a phan-
tom power supply unit.
Put the foam windshield provided on the
microphone cartridge (4) to suppress pop
noise and to protect the microphone from the
moisture from your breath.
Vertrieb von JTS-Produkten – Distribution of JTS products
4 Operation
To switch the microphone on and off, press the
Please
switch
(6). The LED indicator (5) will light up
when the microphone is switched on.
When the volume is too high or the sound
is distorted, set the switch (2) to the position
"−10 dB" to attenuate the signal level by
10 dB.
To suppress low-frequency noise (e. g. impact
sound), set the switch (3) to the position 〘 to
activate the high pass filter.
5 Specifications
Microphone system: . . . condenser micro-
Polar pattern: . . . . . . . . cardioid
Frequency range: . . . . . 20 – 20 000 Hz
Nominal impedance: . . . 100 Ω
Sensitivity: . . . . . . . . . . . 15.8 mV/ Pa
S / N ratio: . . . . . . . . . . . ≥ 78 dB
Maximum SPL: . . . . . . . 140 dB
.
High pass filter: . . . . . . . 80 Hz,
Signal attenuation: . . . . 10 dB,
Output: . . . . . . . . . . . . . XLR, balanced
1
2
3
Power supply: . . . . . . . . phantom power
Dimensions of the base: 96 × 46 × 113 mm
Gooseneck length: . . . . 122 mm
Weight: . . . . . . . . . . . . 748 g
dB
+10
0
−10
20
➂
Frequency response
®
MONACOR INTERNATIONAL GmbH & Co. KG, Zum Falsch 36, 28307 Bremen, Germany
Copyright
©
by MONACOR INTERNATIONAL. All rights reserved.
phone
can be activated
can be activated
1
Ground
2
Signal +
3
Signal −
supply 36 – 52 V
100
200
500
ST-5000T
Order number 23.6890
Desktop Microphone
1
4
5
ON
6
➀
0
30°
5
10
60°
15
20
25
90°
dB
120°
150°
180°
125Hz
2kHz
250Hz
4kHz
500Hz
8kHz
1000Hz
16kHz
➁
Polar pattern
1 k
2 k
5 k
Subject to technical modification.
A-2063.99.01.06.2020
2
3
0
−10 dB
30°
60°
90°
120°
150°
10 k
20 kHz
Publicidad
