Hunter The Care Free Permawick 34407 Manual De Instrucciones página 13

Humidifier Maintenance (continued)
11. Do not expose Motor or other electrical components to water. Do not use a wet towel on
the Motor or Motor Housing as electrical shock may occur.
12. Remove the Water Tank from the base and empty it of any remaining water. Fill the Water
Tank with a mixture of one (1) gallon of water and eight (8) ounces of white vinegar. Leave
the mixture in the Water Tank for 20 minutes, giving the Water Tank a shake every few
minutes. After 20 minutes, give the Water Tank a final shake and discard the mixture. Rinse
the Water Tank several times with clean water. Leave the Water Tank Cap off to allow the
Water Tank to dry completely.
13. Fill the Base with a mixture of one (1) gallon of water and eight (8) ounces of white vinegar.
Leave the mixture in the Base for 20 minutes, then discard the mixture. Rinse the Base well
with clean water and let it air dry or wipe it dry with a cloth.
14. Rinse the Shower Head, Pump Cap, Tubing, Pump, and Motor Shaft Stopper Ring in clean
water to remove any debris. If the parts show hard water residue, soak them in a mixture
of one (1) gallon of water and eight (8) ounces of white vinegar for 20 minutes, then rinse
the parts well with clean water.
15. Wipe the surfaces of the main housing with a soft damp cloth.
16. Once all the parts are clean, reassemble the humidifier. NOTE: The underside of Motor
Shaft Stopper Ring has a groove that fits over two nibs on the Motor Shaft. See Figure 13.
The groove and the nibs MUST BE MATED for the humidifier to be properly reassembled.
Motor Shaft
Stopper Ring
17. Follow the USING YOUR HUMIdIFIER section to continue use. If you are storing the
humidifier, make sure the parts are completely dry.
43002-01 05/30/2007
Groove
Motor Shaft
Figure 13
13
Nibs
© 2007 Hunter Fan Co.