Refilling The Water Tank - Hunter The Care Free Permawick 34407 Manual De Instrucciones

Humidifier Features and Options (continued)
Span Setting
Your humidifier is set at the factory to cycle at setting 2. If you find your humidifier is cycling
either too often of not often enough, change the Span setting to change the cycle time.
1. To see the current Span setting, press both the Humidity and Speed buttons.
2. To change the Span setting, Press and hold both the Humidity and Speed buttons for 3
seconds. The LED Display will flash the current Span Setting.
3. Press the Speed button to change the Span setting. Set the Span to 3 to increase the
humidifier's run time. Set the Span to 1 to decrease the humidifier's run time.
4. When the LED Display shows your desired Span setting, release the Speed button. After
two seconds, the Span is set and the LED Display will show the relative humidity.
The NiteGlo™ Night Light
Press the NiteGlo™ button on the Control Panel to turn the night light on and off. The Nite-
Glo™ night light can be turned on even when the humidifier is turned off.
1. When the water tank level is low, turn the humidifier 'OFF', and unplug.
2. Remove the tank and take it to the sink or tub to refill.
3. Turn the tank upside down and unscrew the tank cap by turning it counterclockwise. Empty the
tank, refill with fresh cool water (never use hot water), and replace the tank cap. Be sure not to
overfill the tank as water damage may occur to furniture or flooring due to spillage. HUNTER
WILL NOT ACCEPT RESPONSIBILITY FOR dAMAGE TO PROPERTY CAUSEd BY
WATER SPILLAGE.
4. Carry the tank back to the humidifier. Turn the tank upright and place it on the humidifier.
Be sure that the tank is seated properly in the base. If the tank is properly located on the
base, you will see air bubbles flowing up into the tank.
43002-01 05/30/2007

Refilling The Water Tank

8 © 2007 Hunter Fan Co.