Publicidad
Step 12
Carefully turn your unit over onto its front edges. Unfold the
å
BACK (F) and lay it over your unit.
A perforation in the BACK (F) has been provided for access
å
to the SAFETY STRAP (60M). Punch out the perforation
and push the SAFETY STRAP through the hole.
Make equal margins along the top and bottom edges of
å
the BACK (F). Then, make equal margins along the side
edges of the BACK. Push on opposite corners of your unit if
needed to make it "square".
Fasten the BACK (F) to your unit using the NAILS (1N).
å
NOTE: Be sure to tap NAILS into the holes that line up over
å
the SHELF (E).
NOTE: You may need to gently tap in the
å
MOLDING CONNECTORS.
NAIL
(51 used in this step)
Page 16
These holes must line
up over the SHELF (E).
1N
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
F
422595
Before fastening the
BACK, punch out the
perforation and push
the SAFETY STRAP
through the hole.
60M
Using your
hammer, gently
tap in MOLDING
CONNECTORS.
www.sauder.com/services
Publicidad
