Opening Manual; Maintenance; Exploded View And Spare Parts; Scrapping - Diamond DRW30-TM Manual De Instrucciones

E030301B
connected to a single magneto-thermal
switch and power cut-off safety device.
For high spin washing machines with the
frequency control (inverter) you should
specifically provide:
1-phase inverter by RCD type A
-
(pulse-current sensitive FI's)
type B (all-current sensitive FI's)
3-phase inverter by RCMA's with
-
separation or RCD's type B (all-
current sensitive FI's)
Each machine must be connected to an
earth. The builder is not responsible for
any consequence
neglecting of safety regulations.
When connecting the wires be sure not to
mistake the neutral for one of the phases
wires! Before connecting every electric
connection always
reference rating. For any problem, follow
the electric
machine.
Please note:
machines are equipped with frequency
control (inverter).
When the electric power is produced by a diesel
generator, the inverter requires the application of
one further inductance.
10.1 CHANGE OF ELECTRIC FEED
If it is necessary to change the electric feed
indicated to the reference rating, please contact
the builder after sales service.
11. START UP AND TESTING OF MACHINE
Once all connection have been made, the
machine have to start up following the proper
procedures that its control equipment required.
The installer must control every single part of the
machine; in particular the installer should attend at
least a whole machine cycle; in this case do load
the machine fully and verify the correct positioning
of the end unbalance running (only for High spin
washing machines).
12. MANUAL OPENING DOOR
During the cycle it could be necessary the manual
opening door without the help of automatic
unblock through the keyboard.
To open the door is necessary the use of an
utensil.
Machine without handle. Use a cross screwdriver
to open the inferior front panel. To open the door,
pull the cord on the left side.
arising from
check machine
scheme enclosed
All high spin washing
Machine with handle. Use a cut screwdriver to
push high the block peg, using also the handle
(see the picture).
or
the

13. MAINTENANCE

Only qualified technicians should service the
with
machine: before servicing be sure to turn off all
feeding connections.
Anyway the following operations should be
performed
maintenance can be determined according to
frequency of use of each machine:
Daily maintenance
ü
The machine must be kept clean using
neutral soap: wipe the external panels
and the soap compartment to eliminate
residual soap;
ü
Control the drain valve does not leak
while it is running.
ü
Clean the door gasket.
ü
At the end of the day, after operation and
cleaning, leave the door opened in order
to air the machine interior.
ü
-After working it is advisable to turn off
steam, power and water main switches.
Quarterly maintenance
ü
Check the transmission belts tension and
replace belts in case of wear.
ü
Remove the machine cover and check the
whole electric wiring.
ü
Check piping and bellows out for leaks.
Six-monthly maintenance
ü
Clean the water inlet filters and steam
filters.
ü
Clean inner-drum, drainage and out-let
tubes from lint
ü
Grease the machine bearings.
ü
Clean electronic parts from dust.
11
regularly; the frequency
08/09/03
of