Publicidad
Step 8
Fasten the RIGHT END (A) to the TOP (E) and BOTTOM (F).
å
Tighten four HIDDEN CAMS.
Fasten four ANGLE BRACKETS (27G) to the TOP (E). Use
å
four BLACK 9/16" LARGE HEAD SCREWS (1S).
Fasten the TOP MOLDING (M) to the TOP (E). Use four
å
BLACK 9/16" LARGE HEAD SCREWS (1S) through the
ANGLE BRACKETS on the TOP and into the TOP MOLDING.
NOTE: There are no pre-drilled holes in the TOP MOLDING.
å
The SCREWS will tighten into the groove.
Maximum
210 degrees
Minimum
190 degrees
Page 12
(4 used)
F
Arrow
BLACK 9/16" LARGE HEAD SCREW
27G
(8 used in this step)
M
E
Don't worry. It isn't
Rome. This can be built
in a day.
1S
Groove
Wide edge
K
A
u t
i t h o
e w
M S
f a c
C A
S u r
D E N
H I D
Publicidad
