Cleaning Instructions - Palram Arcadia 5000 Instrucciones De Montaje

EN
IMPORTANT
Please read these instructions carefully before you start to assemble this greenhouse.
Please carry out the steps in the order set out in these instructions.
Keep these instructions in a safe place for future reference.
» Care and Safety advice
•
Please follow the instructions as listed in this manual.
•
Sort the parts and check against the list of contents.
•
For safety purposes we strongly recommend that the product will be assembled
by at least two people.
•
Some parts have metal edges. Please be careful when handling components.
Always wear gloves, shoes and safety goggles during assembly.
•
Do not attempt to assemble the carport in windy or wet conditions.
•
Dispose of all plastic bags safely – keep them out of reach of small children.
•
Keep children away from the assembly area.
•
Do not attempt to assemble the carport if you are tired, have taken drugs,
medications or alcohol, or if you are prone to dizzy spells.
•
When using a stepladder or power tools, ensure that you are follow the
manufacturer's safety advice.
•
Do not climb or stand on the roof.
•
Heavy articles should not be leaned against the poles.
•
Do not hang or lay on part 216.
•
Please consult your local authorities if any permits are required to erect carport.
•
Keep roof and gutters clean of snow, durt & leaves.
•
Heavy amounts of snow on roof can damage the carport making it unsafe to
stand below or nearby.
•
This product was designed and produced to be a carport only.
»
Some versions of this carport are painted.
If color was scratched during assembly it can be fixed with the following tints:
Gray – RAL 7012
» Cleaning instructions
When your carport needs cleaning, use a mild detergent solution and rinse with
cold clean water.
Do not use acetone, abrasive cleaners, or others special detergents to clean the panel.
» Before stating assembly
•
This carport must be assembled on a solid base (such as concrete or asphalt).
•
Choose your site carefully before beginning assembly. Site surface (mainly below poles)
needs to be level.
•
During assembly use a soft platform below the parts to avoid scratches and damages.
» TOO1
» Notes (by steps)
Step 7: Screw 4000 intended to keep the parts (gable) stable
till gutters will be assembled. If a third person can hold the
parts till step 8, this screw can be assembled with all the
others at step 33.
Approx.
Dim.
242 cm
95.3"
501 cm / 197.2"
214 cm / 84.3"
During assembly some screws are fastened fully by wrench
while others are fastened just after the whole carport is
assembled and leveled (step 21).
Tighten all screws when completing assembly.
Notice the marks on each step:
195 cm
76.8"
325 cm / 130"
363 cm / 142.9"