essentiel b ERBT 2 Manual De Utilización página 34

p
RepaRiNg hot iNgRedieNts
Never pour boiling liquids into the bowl or jar (4
•
and 10).
If you prepare hot drinks or soups, let the ingredients
•
cool to a temperature below approximately 60°C
(warm) before pouring them into the blender and
do not exceed 900 ml.
• When mixing hot liquids, particular attention should be paid to prevent hot liquid spray that
could cause burns. Don't forget to close the filling hole in the lid with the measuring cap
(12).
• If the lid lifts up, especially when mixing hot preparations, switch off the appliance and
remove the lid to relieve the built-up pressure. Then repeat the operation while holding the
lid firmly in place. You can also pour out part of the preparation and mix it in several stages.
After use/disassembling the various components
a
fteR use
Always turn off the appliance (on/off button at speed 0) and unplug it from the power point
before removing the food processor bowl (4) or the blender jar (10) from the motor unit.
W
ith the food pRoCessoR boWl
1. Take the feed tube pusher (7) out of the lid (6).
2. Turn the lid (6) anticlockwise, lift it up and remove it.
3. Depending on the accessories used, remove the slicing disc (15 or 16) and then the drive
shaft (3) or chopping knife (13) or emulsifying disc (14) and then the drive shaft (5).
4. Turn the food processor bowl anticlockwise to unlock it from the base of the motor unit.
Lift it up and remove it.
W
ith the bleNdeR jaR
1. Remove the lid (11) and its measuring cap (12).
2. Turn the food processor bowl anticlockwise to unlock it from the base of the motor unit.
Lift it up and remove it.
3. Pour the preparation into glasses (or another container).
4. You can remove the blade assembly (8) to make it easier to clean the bowl. To do this, turn
the blade assembly slightly anticlockwise, and then remove it.
34
V.1.0 V.1.0
use
(4)
(10)