Hazet-Werk 4902/6 Manual De Instrucciones página 14

• Insert bottom tensioning jaw
into the coil spring (figure 1).
• Push spindle, thrust piece and drive from
below through the suspension arm and the
spring upwards until reaching the bottom the
tensioning jaw.
• Push upper tensioning jaw
spindle (figure 2).
• Lower the splindle's
from the top downwards into the reception
hole of the upper tensioning jaw (figure 3).
• Check correct fit and assembly of the 6-
point cap (calotte) (figure 3).
• Pretension the system and check the spring's
tight fit all around the internal guidance
(figure 4).
• Operate drive with the tubular box-end
6
wrench and the reversible ratchet
(figure 5).
• When removing the spring from the fixing
device/rubber protectors, retain with tubular
box-end wrench
7
twisting of the tensioning jaw.
14
3 Design and Function
5
from the side
4
onto the
1
6-point cap (calotte)
8
in order to avoid turning/
fig. 1
fig. 2
fig. 3
4
5
1
6
7
8
fig. 4
fig. 5