Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
system switches off your steam generator. To
start your ironing again, press the «ON-OFF»
button.
MAINTENANCE AND CLEANING
Do not use any cleaning or descaling
products for cleaning the soleplate or
the base-unit. Never hold the iron or
the base unit under the tap.
11 • Cleaning the station
•
The iron soleplate:
your iron when it is cool with a damp
cloth or a non-abrasive sponge.
•
The base unit:
Clean the plastic parts of the
appliance occasionally with a soft cloth.
12 • Easy descaling of your
steam station
Do not use any descaling substances
(vinegar, industrial descaling products,
etc.) when rinsing the scale collector: they
could damage it.
Before emptying your steam station, it
must always be left to cool for 2 hours to
avoid any risks of scalding.
The water in the appliance may still be
hot and cause burns even after 2 hours of
cooling down. Handle the appliance with
care when then collector is removed,
particularly when you are emptying it.
• To extend the life of your steam station and
avoid scale on your ironing, your steam station
is equipped with a built-in scale collector. This
collector, located in the boiler, automatically
removes the scale that forms inside.
Operation:
• An orange "Calc Away OK button" light located
fig. 15
-
on the control panel starts flashing to
tell you that the scale collector needs rinsing.
• Once the steam station has cooled completely,
remove the scale collector -
IMPORTANT! This operation must not be
carried out unless the steam station has
been unplugged for at least two hours and
has cooled down completely. To carry out
this operation, the steam station must be
close to a sink as water may come out of
the tank when it is opened.
Clean the soleplate of
fig.
16.
• Unscrew the scale collector and remove it
from the housing; it contains the scale
that has built up in the tank -
• To clean the collector properly, just rinse it
under running water to remove the scale
fig.
it contains -
• Put the collector back into its housing and
screw it in completely to keep it
fig.
watertight -
The next time you use your iron,
press the "Restart OK button" button
on the control panel to turn off the
orange "Calc Away OK Button" light.
Twice a year:
In addition to this regular maintenance
procedure, we recommend that you rinse
the boiler completely once every 6 months,
or once every 25 times you use your steam
station.
• Make sure that the steam station has
been unplugged and allowed to cool for
at least 2 hours.
• Place the steam station on the edge of
your sink and the iron to one side, on its
heel.
• unscrew the scale collector -
• Hold your steam station at an angle and
use a jug to fill the boiler with 1/4 litre of
fig.
tap water.-
• Shake the base unit for a few seconds
then empty it completely into the sink.-
fig.
25-26.
• Fit the collector back in its housing
and screw it on tightly to ensure it is
watertight but do not overtighten it -
fig.
19.
The steam station does not work
without the scale collector / boiler rinse
cap (according to model).
Regular descaling of your steam
station helps to maintain its steam
performance over time
12
fig.
18.
19.
fig.
24.
17.
16-17.
Publicidad
Tabla de contenido
