GE AJCM 08, 10 ACD Serie Manual Del Propietario Y Instrucciones De Instalación página 20

WINDOW INSTALLATION—OPTIONAL (cont.)
INSTALL CASE IN WINDOW
7
Peel off the backing from the bottom window
A
gasket.
B
Place the gasket on the stool and over the
brackets, even with the rear edge, sticky
side down.
Bottom window gasket
C Carefully slide the empty case into the window
until the holes in the case line up with the holes
in the panel angles.
Case holes
OTES:
N
• The case should have a 1/8" minimum tilt toward
the outside.
• Be sure the seal gasket and panel gaskets remain
in position and do not roll with the case.
Lower the window so it fits behind the panel tabs.
D
Insert the 4 type A screws through the holes in the
case and into the panel angles, 2 on each side.
Panel
tabs
Installation Instructions
Case
screws
E
With the window closed, mark where the window
sash meets the case.
F Peel off the backing from the case top gasket.
G Hold on to the case, open the window and place
the gasket along the mark on the case.
Put the gasket on
top of the case
where the window
will close.
Place the vinyl window gasket over the case top
H
gasket. Insert the panel tabs through the slits in
the gasket. Cut the gasket on each side to the width
of the window.
Panel tab
I Close the window tightly on the vinyl gasket.
Bend the gasket forward to expose the panel tabs.
Drill pilot holes into the window sash.
20
Vinyl window gasket
Attach the panel tab
to the window on each side
with a type D screw.