Lutron Stanza Instrucciones De Instalación

Stanza
®
Installation Instructions
Please Read Before Installing
Indicator
light flashes
when card is
not present
Insert room
key card as
indicated by
engraving
Card Switch Operation
Mounting
Card
switch
mounting
screws
Card
switch
Technical support:
USA, Canada, Caribbean: 1.800.523.9466
Mexico: +1.888.235.2910
Central/South America: +1.610.282.6701
Warranty: 1-year limited warranty standard. 2-year parts and labor warranty,
with 8-year pro-rated parts replacement on systems that include factory startup.
www.lutron.com/TechnicalDocumentLibrary/Warranty_CommercialSystems.pdf
Lutron, the sunburst logo, and Stanza are registered trademarks of Lutron Electronics Co., Inc.
© 2011 Lutron Electronics Co., Inc.
English
Faceplate
adapter
mounting
screws
Faceplate
adapter
Faceplate
Faceplate adapter and faceplate purchased separately.
R
Stanza Card Switch Guest Room Control
SZ-CS-CCO
12 – 24 V or 12 – 24 V
Important Notes
Install in accordance with all local and national electrical
codes.
Environment: Ambient operating temperature: 32 to 104 °F
(0 to 40 °C), 0 to 90% humidity, non-condensing. Indoor use
only.
Cleaning: To clean, wipe with a clean damp cloth. DO NOT
use any chemical cleaning solutions.
WARNING! Shock hazard. Could result in serious
injury or death. To avoid risk of electrical shock, do
not attempt to open the card switch.
Replacement: It is not necessary to rewire
a unit you are replacing; simply remove
the terminal block and attached wires from
the original card switch, and replace it into
the new card switch. Note that older card
switches may have different terminal labels,
as shown here; rewiring is not required.
100 mA
15-24 V /
1.COM
2.V+
3.CCO
4.CCO COM
U10 CB
Lutron Electronics Co., Inc.
Made and print ed in the U.S.A.
P/N 030-1544 Rev. B 04.12.11