Final Installation; Handheld Remote Control Assembly - Craftmade Cortana CR52-LED Guia De Instalacion

11. Final Installation.

Replace fitter plate on motor plate and secure with
2 screws that were previously removed.
Re-tighten the 3 loosened screws in outer edge of
motor plate. [Important: Make sure to tighten these
screws uniformly so that the fitter plate is centered
inside the motor plate once all 3 screws have been
re-tightened.]
Place fitter plate cover over fitter plate. Secure fitter
plate cover with finial provided.
PLEASE NOTE: This fan is light kit adaptable (optional)
but ONLY with Model # CRLK-PR. Call Customer Support
at 1-800-486-4892 for more information.
12. Handheld Remote Control
Assembly.
IN ORDER TO USE THE HANDHELD REMOTE CONTROL,
CONTINUE WITH SECTION 12 for remote control
assembly instructions. If you have already installed the
wall control but do not wish to use the handheld remote
control, please proceed to Section 13.
Gently pull on remote control cover to separate top
and bottom parts. [Refer to diagram 1.]
In order to use wall control as a handheld remote
control, cut each wire on wall control (that was not
previously used)--use wire cutters to cut off each wire
as close to the wall control as possible. [Refer to
diagram 2.]
Install one 12-volt battery (included) in wall control.
[Refer to diagram 2.]
The LED bulbs provided with this fan are not
compatible with dimmer controls; therefore, the
dimmer switch (labeled ON and D) has been pre-set
to the "OFF" position (D). If you wish to have dimming
capability, you will need to use a different type of
bulb (sold separately) and the switch must be moved
to the "ON" position (ON). [Refer to diagram 2.]
Align holes in wall control with posts located on
inside of TOP part of remote control cover and press
together firmly. Place wall control into BOTTOM part
of remote control cover, aligning posts in top of
remote control cover with post holes in the bottom.
[Refer to diagram 3.]
(NOTE: Make sure to align narrower ends of remote
control cover before closing.) Squeeze top and
bottom of remote control cover together until you
hear a click at each end, indicating that the remote
control cover has closed completely.
(bottom)
diagram 1
dimmer
switch
diagram 2
post
hole
remote control
cover, BOTTOM
diagram 3
page 8
fitter plate
fitter plate cover
finial
remote control
cover
wall control
wire
III IV
II V
VI
I
wire
wire
12V battery
hole
IV
III
II V
VI
I
wall
remote control
control
cover, TOP
(top)
post