Remote Control; Energy Saver - GE ADQ12 Manual Del Propietario E Instrucciones De Instalación

About the controls on the air conditioner—models with touch pads.
Features and appearance will vary.
Fan speed
on
Air Conditioner Controls
Controls
ON/OFF Pad
Turns air conditioner on and off.
Display
Shows the set temperature or time remaining
on timer.
MODE
Use to set the air conditioner to COOL or
FAN mode. NOTE: When setting the mode using
the remote control, use the separate COOL and
FAN pads.
Increase
Use to set temperature when in COOL mode.
FAN Pad
Use to set the fan speed to LOW , MED or
HIGH.

ENERGY SAVER

the fan.
ON—The fan runs on low speed while the
compressor cycles on and off and the set
temperature will automatically increase by
2°F. This results in wider variations of room

Remote Control

s
To ensure proper operation, aim the remote
control at the signal receiver on the air
conditioner.
s
The remote control signal has a range of
up to 24 feet.
4
v w
/Decrease Pads
—
(on some models) Controls
Cool on
Fan on
Remote Control
temperature and humidity. Normally used
when the room is unoccupied. NOTE: The fan
will continue to run on low speed only after the
compressor cycles off.
OFF—The fan runs all the time, while the
compressor cycles on and off.
This feature must be set at OFF in order to
use the fan settings (on the mode control).
TIMER Pad
ON—When the air conditioner is off, it can be
set to automatically come on in 1 to 12 hours
at its previous setting. Each touch will set the
timer in hours.
OFF—When the air conditioner is on, it can
be set to automatically turn off in 1 to 12
hours. Each touch will set the timer in hours.
To cancel the timer, press the TIMER pad
until the display time disappears.
Remote Control Signal Receiver
s
Make sure nothing is between the air conditioner
and the remote control that could block the
signal.
s
Make sure batteries are fresh and installed
correctly as indicated on the remote control.