GE ADQ12 Manual Del Propietario E Instrucciones De Instalación página 12

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

3
REMOVE THE AIR CONDITIONER
FROM THE CASE
Remove and discard the 2 shipping screws
A
from the bottom rear of the case.
Grasp the filter tab at the bottom center of
B
the grille and pull the filter down and out.
On models with control knobs, remove them
C
by pulling them straight off their shafts.
Grasp the lower corners of the grille frame
D
while pressing in on the case sides with your
finger tips. Pull out to release and lift it up.
NOTE: Do not pull the
bottom edge toward
you more than 3 " or
you may damage the
tabs of the grille.
Installation Instructions
12
3
REMOVE THE AIR CONDITIONER
FROM THE CASE (CONT.)
On some models, you must also
E
disconnect the control connectors before
the grille frame can be removed. Press the
locking tabs in while pulling on the other
side to release.
Remove the locking screw and locking
F
bracket from the lower frame.
Remove the screw and washer securing
G
the ground wire to the right side face of
the unit.
Washer
Slide the air conditioner from the case by
H
gripping the base pan handle and pulling
forward while bracing the case.
Press in
Pull
Press in
Ground wire
Screw

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Adv12Adq14Adv14

Tabla de contenido