Remote
MODE button: select
ventilation mode: nor-
mal, natural or night
ATTENTION:
command can only
be accessed from
the remote control.
normal: operates at
the selected speed
natural:
speeds randomly
Night: Gradually re-
duces speeds to a
stop (30 minutes for
each speed)
Note: the corresponding lights on the
control panel light up to indicate the
selected mode (normal, natural or night)
NOTE : The MIST, TIMER, SPEED/ON,
standBY and osCillation buttons
Tilt
Rev 0-02 12 19
perform the same actions as the corres-
ponding buttons on the control panel.
The remote control is supplied without
this
battery.
This remote control uses two batteries
of lR03_aaa_1.5V type. do not use
other types of batteries.
When installing and replacing the batte-
ries, make sure that they are installed
correctly, respecting the polarity.
alternates
In case of prolonged non-operation,
remove the batteries from the remote
control.
Do not dispose of used batteries in the
domestic waste bin. Discard them in a
suitable place for recycling batteries.
1. For your safety, make sure the fan is in the off position
before tilting the head.
2. Loosen the screw on the side of the fan head (see
figure).
3. Using the handle on the rear grille, gently pull the grille
up or down to the desired angle.
4. Tighten the screw securely to hold the head in the
desired position.
Fabriqué en Chine
Page 32