HAMPTON BAY 675-458 Manual De Instrucciones página 3

PARTS INCLUDED FOR ASSEMBLY (parts are not to scale):
(1) 48in. Linear Track
FIELD CUTTING TRACK TO SPECIAL LENGTHS (OPTIONAL):
NEW CUT MUST BE AT AN EXACT
RIGHT ANGLE (90°)
REDRILL
MOUNTING
HOLE(S) IF
NECESSARY
Note: Cutting should be done preferably from the dead end of the track.
1. Remove dead end fitting and pull copper bus bars and insulators flush or even with
one end of the track.
2. With a hacksaw, cut the flush end (the side with insulators and bus bars even to end) to
desired length. Be sure to allow 1/8
to the track end.
3. Remove all burrs from the track, insulators and copper bus bars.
4. Push copper bus bars back into the insulators 3/8
Note: After you complete step 4, bus bar insulators should be a minimum of 3/8
maximum of ½ in. from each end of the insulator. If this is not the case, make
appropriate modifications.
5. Reinstall the dead end and/or appropriate feed connector and tighten the screw.
CAUTION: After track has been field cut, make certain that each length of track that is 4
feet (1.22m) or less in length has one mounting opening spaced a maximum of 6 in.
(150mm) from each track end section. A single section of track that is greater than 4 feet
(1.22m) in length must have mounting openings a maximum of 12 in (300 mm). from each
end of the track with additional openings a minimum of every 4 feet (1.22m) long the
length of the track section. Additional openings every 4 feet (1.22m) along the track
section may be added as needed.
IF ADDITIONAL MOUNTING HOLES ARE NEEDED (OPTIONAL):
1. Locate desired mounting hole(s) on the inside of the track section along the center line.
th
2. Using 3/16 in. diameter drill bit, drill a hole through the track channel.
CAUTION: Take care that you do not damage the bus bar insulators during the drilling
operation. If you accidentally damage any insulators, discard the track section. To
prevent the risk of fire, or injury to person(s), DO NOT ATTEMPT TO USE IT IN
THE INSTALLATION.
3. Remove all burrs and install track as described above.
(2) Toggle bolts (2) Tapped Screws
th
in. for dead end fitting which must be reinstalled
th
in. from the end of the insulators.
3
(2) Anchors
TO REMOVE DEAD
END FITTING.
LOOSEN SCREW
AND SLIDE FITTING
OUT.
th
in. and a