9. Carrying the Water Tank by the two upper handles on the
top of the Tank, position the Water Tank so that the notch in
the back fits over the power supply cord and the Tank Cap in
front fits into the cut-out area of the Power Pack. See Figure
6.
Tank Cap
Cut-out area of
power pack
Figure 6
NOTE: Do not carry the Water Tank by the exhaust vents. See
Figure 7.
Figure 7
10. If the Water Tank is properly seated, you will see air
bubbles flowing up into the tank. If you do not see air
bubbles, reposition the Water Tank as instructed above.
Make sure the Power Knob is set to OFF and plug the
humidifier into the wall outlet.
CAUTION: Never plug in the humidifier while your hands are
wet, as electric shock could occur.
11. Thread the power cord through both power cord clips on the
back of the humidifier.
12. Turn the Power Knob to the desired setting.
NOTE: If the Water Tank is not seated properly on the Power
Pack, it will not turn on.
©2008 Hunter Fan Co.
1. Adjustable Humidistat – Allows you to adjust the humidity
Power
pack
2. Power Knob – Allows you to set a desired speed level. See
Do not carry the
water tank by the
exhaust vents.
Upper
Handle
Turn the dial to set the speed to High, Medium. Low and Off.
Exhaust
See figure 10.
Vents
4
Operating Your Humidifier
setting. See Figure 8.
Adjustable
Humidistat
Knob
Figure 8
• Turn the dial to the right to increase humidity.
• Turn the dial to the left to decrease humidity.
Figure 9.
Power
Knob
Figure 9
high
LOW
Figure 10
MEDIUM
OFF
41785 Rev 05-06-2008