Hunter The Care Free Ultra Manual De Instrucciones página 7

3. Place the Atomizer in the Upper Reservoir, aligning the
three oval holes in the Atomizer with the three prongs in the
Upper Reservoir. The side of the Atomizer with three short
posts should be facing upward. See Figure 17.
Posts
Atomizer
Figure 17
4. Assemble the Pump Cap and the Funnel Pump by aligning
the arrows on both components and inserting the Funnel
Pump into the Pump Cap. Twist the Funnel Pump counter-
clockwise until the two components snap together. See
figures 18a and 18b.
Pump Cap
Funnel
Pump
Figure 18a
Arrows
Figure 18b
©2008 Hunter Fan Co.
5. Attach the Funnel Pump Assembly to the Power Pack by
engaging the three tabs on the underside of the fan blade.
See Figure 19.
Fan Blade Under-
side
Power Pack
Funnel Pump
Assembly
Figure 19
6. Place the Power Pack into the Upper Reservoir so that the
three prongs in the Power Pack go through all three holes
in the Atomizer and into the three prongs in the base of the
Upper Reservoir. Make sure the Power Pack is securely
seated and all three prongs are in the proper position. See
Figure 20.
Pump
Cap
Figure 20
NOTE: The prongs will only fit into the Upper Reservoir one
way.
7. Follow the directions in the section REFILLING THE WATER
Funnel
TANK to complete reassembly.
Pump
7
Tabs
Power Pack
Atomizer
Holes in the
Atomizer
Upper
Reservoir
41785 Rev 05-06-2008