Cleaning And Maintenance - Krups BW600 Manual De Instrucciones

IFU_KR_KETTLE_NC00019203_NAFTA_Mise en page 1 10/11/10 10:40 Page8
English
4. Plug in the kettle, then place the kettle on its base.
5. To turn the kettle on and begin boiling, press the
ON /OFF button located at the bottom of the kettle
under the handle.
6. The kettle may have an internal light, depending on
model
7. The kettle will automatically switch off and the
indicator light will go out once water boils.

CLEANING AND MAINTENANCE

DO NOT LEAVE WATER IN THE KETTLE AFTER USE.
EMPTY THE KETTLE AFTER EACH USE TO REDUCE
ACCUMULATION OF LIMESCALE DEPOSITS.
To clean the kettle and base
n
Always unplug the base and allow the kettle to cool before cleaning.
n
Avoid exposing the base or the bottom of the kettle to excess water. To
protect against risk of electrical shock, do not immerse the base in water
or any other liquid, or place under running water to clean. Wipe clean
with a damp sponge and a small amount of gentle dishwashing liquid if
necessary. Never clean with harsh or abrasive cleaners or sponges. Dry
all parts carefully before next use.
To clean the limescale filter
n
Always unplug the base and allow the kettle to cool before cleaning.
n
The limescale filter is a removable mesh filter in the spout of the kettle.
This filter does not treat or remove the scale from the water, it traps the
scale particles from being poured out.
n
With very hard water, the filter may need to be cleaned as often as 10-
15 uses. If the filter is wet, run under lukewarm water to remove
particles. If filter is dry, brush gently to remove particles. To avoid
damaging the mesh, do not scrub the filter.
n
To remove excessive scale, descale as described below.
8
(fig. 4)
(fig. 5)