INSTALLATION WITH COMPOSITE VIDEO
1. Insert the coaxial cable from the antenna to the ANT IN input
on your HDTV tuner.
2. Locate the audio and video outputs on your TV and connect
one end of the RCA cables to them. The other end should be
connected to the Video and Audio R/L jacks on the tuner. Make
sure that the colors on the cables and the colors on the jacks
correspond.
3. Set the switch in the CVSB position.
4. Insert the power cable in the tuner and connect the other end
to the home power source.
It is possible that when you power the receiver on, the LED
It is possible that when you power the receiver on, the LED
indicator is blinking. If this happens, disconnect the power
indicator is blinking. If this happens, disconnect the power
adaptor and connect it again. The LED indicator should
adaptor and connect it again. The LED indicator should
illuminate red.
illuminate red.
INSTALLATION WITH COMPONENT VIDEO
1. Insert the coaxial cable from the antenna to the ANT IN input
on your HDTV tuner.
2. Locate the component video outputs on your TV and connect
one end of the RCA cables to them. The other end should be
connected to the Y, Pb, and Pr jacks on the tuner. Make sure
that the colors on the cables and the colors on the jacks
correspond.
3. Locate the audio outputs on your TV and connect the RCA
cables from these jacks to the receiver's jacks. Make sure the
color coding corresponds on both the TV and the tuner.
4. Set the switch in the YPbPr position.
ENGLISH-5