Bushnell EliteTactical Manual Del Proprietário página 5

RESETTING THE WINDAGE T-LOK™ TURRET
Step 1
After pulling it up to allow adjustment, rotate the windage dial counterclockwise to move the reticle plane right, or
clockwise to move it left. Bushnell XRS II riflescopes provide 10 mils of adjustment per complete revolution of the turret.
Afteradjustmentshavebeenmade,youcanresettheturrettozerobyfollowingthestepsbelow:
• Step 1: Ensure the turret is in the locked position.
• Step 2:Useacoinorflatheadscrewdrivertoremovetheturretscrewfoundontopoftheturretknob,beingcarefulnot
to displace the o-ring found under the turret knob.
• Step 3: Remove the turret knob and return it to the turret, with the "zero" mark on the knob lining up with the vertical
index line on the turret.
• Step 4: Return turret screw to top of knob and tighten down, making sure the turret knob is in the locked position so
theturretknobdoesnotturnorshiftpositionwhiletighteningthescrew.Avoidovertightening.
RESETTING THE ELEVATION TURRET
Rotate the elevation turret knob counterclockwise to move the reticle plane up, or clockwise to move it down. One full
revolution of the elevation dial will move the point of impact 10 mils at any distance.
Afterzeroingyourrifle,youcanresettheelevationturrettozerobyfollowingthesesteps:
• Step 1:Useacoin,flatheadscrewdriverorcartridgerimtoremovetheturretscrewfoundontopoftheturretknob,
being careful not to displace the o-ring found under the turret knob.
• Step 2: Remove the turret knob and return it to the turret with the "zero" mark on the knob lining up with the vertical
index line on the turret.
• Step 3: Return turret screw to top of knob and tighten down making sure the turret knob is in the locked position so the
turret knob does not turn while tightening the screw.
REVLIMITER™ (ZERO STOP) INSTRUCTIONS (See Photos On Next Page)
• Step 1: O btainagoodzeroonyourrifleat100yds.Removetheturretknobscrewusingacoinorflatheadscrewdriver
(1).
• Step 2: Remove the turret knob and set aside (2a).LoosenthethreeAllensetscrewsfoundontheperimeteroftheblack
innerlockingring1½turns(using1.5mmAllenwrench-provided)(2b). These screws are "captured" in the RevLimiter
ring so that they cannot be completely removed and dropped or lost. Ensure the screws are loosened far enough for
the RevLimiter disk to "bottom out" before you turn it in the next step.
• Step 3:TurntheRevLimiterdiskclockwiseuntilitcontactsthefixedpininthebottomoftheturret(3a). Tighten the three
set screws in the RevLimiter disk to 2 inch lbs (3b). (Do not overtighten). Your zero stop is now set.
• Step 4: Re-index the turret cap to zero and return the turret screw to the top of the turret knob and tighten (4).
Step 4
Step 2
Step 3
RESETTING THE ELEVATION TURRET
Step 1
Step 2
5