Tabla de contenido
Publicidad
Remote Control
1.
LEDs On/Off
2.
LED Mode Select
3.
LED Color Select
®
4.
Bluetooth
Connecting
5.
Power On/Off
6.
Play/Pause
7.
Previous Track *
8.
Next Track *
9.
Volume Up
10. Volume Down
* Note: With some apps, pressing the Previous Track button or Next Track button may go to
another playlist or music genre.
Bluetooth Connecting with Flash Cube
1.
Press and hold the power button for two seconds to power on Flash Cube.
2.
Press and release the Bluetooth Connecting button to enter Connecting Mode. Flash
Cube's Bluetooth LED will blink during the connection process.
3.
Navigate to your device's Bluetooth setup screen, find Flash Cube, and connect. Flash
Cube's Bluetooth LED will light up solid when it is connected.
Note: If you experience trouble in connecting, select Forget this Device on your
Bluetooth device and try to connect again.
4.
To disconnect, hold the Bluetooth Connecting button on Flash Cube for 3 seconds.
Speaker Linking
To link two Flash Cubes together:
1.
Power on each Flash Cube.
2.
If necessary, disconnect previous Bluetooth connections by holding down the Bluetooth
Connecting button for 3 seconds.
3.
Press and release the Link button on each Flash Cube. Flash Cube's Link LED will blink
and a beeping tone will sound on each Flash Cube during the linking process. Linking
may take up to a minute. Once the two Flash Cubes are fully linked, the Link LEDs on
both Flash Cubes will be lit solid.
4.
Press and release the Bluetooth Connecting button on the Flash Cube that you want to
be the master (left channel).
5.
Navigate to your device's Bluetooth setup screen, find Flash Cube, and connect. The
speakers will re-link automatically the next time they are both powered on.
6.
To disconnect linking, hold the Link button on the master Flash Cube for 5 seconds.
Note: When using the remote, there will be a response delay of a few seconds with the play
and pause commands.
3 3
4
1 2 4 5
6
7 7
8
9
10
10
Publicidad
Tabla de contenido
