Accessories And Spare Parts; Scope Of Delivery; Safety Devices; Device Description - Kärcher LMO 18-33 Battery Manual De Instrucciones

Accessories and spare parts

Only use original accessories and original spare parts.
They ensure that the appliance will run fault-free and
safely.
Information on accessories and spare parts can be
found at www.kaercher.com.

Scope of delivery

The scope of delivery for the appliance is shown on the
packaging. Check the contents for completeness when
unpacking. If any accessories are missing or in the
event of any shipping damage, please notify your deal-
er.

Safety devices

Symbols on the device
Follow all warning notices and safety instruc-
tions. Read and comprehend all instructions
before using the product.
Watch out for flung or flying objects.
Keep all spectators, especially children and
pets, at least 15 m away from the work area.
Watch out for the sharp blade. The blades
continue rotating after the motor has been
switched off.
Remove the safety key before performing
any maintenance.
Wear suitable eye protection and hearing
protection when performing work.
Do not work on steep slopes.
Do not subject the device to rain or moist
conditions.
Overload protection
The device is equipped with an overload protection sys-
tem. The device switches off automatically when an
overload is detected.

Device description

The maximum amount of equipment is described in
these operating instructions. Depending on the model
used, there are differences in the scope of delivery (see
packaging).
For the illustrations, refer to the graphics page.
Illustration A
Front wheel
1
Cutting height adjustment lever
2
Battery pack release
3
Battery flap
4
20
Type plate
5
Cable holder
6
Motor control cable
7
Handle
8
Starter button
9
ON/OFF switch
10
Quick-release screw
11
Grass catcher filling level indicator
12
Grass catcher
13
Rear wheel
14
Mulch plug
15
*Charger
16
*Rechargeable battery pack
17
Safety key
18
* optional
Rechargeable battery pack
The device can be 18V Kärcher Battery Power operated
with a battery pack.
Installing the handle
1. Insert the lower section of the handle and allow it to
latch into position at the desired height.
Illustration B
2. Screw the upper section of the handle at the desired
height.
Illustration C
3. Fasten the motor control cable using the cable holder.
Illustration D
Attaching the mulch plug
The mulch plug is used when the mown grass is to re-
main on the lawn.
1. Open the ejection chute flap.
Illustration E
2. Insert the mulch plug into the ejection chute.
3. Close the ejection chute flap.
Installing the grass catcher
The grass catcher is used when the mown grass is to be
collected for disposal.
1. Open the ejection chute flap.
Illustration F
2. Remove the mulch plug.
3. Install the grass catcher on the ejection chute. Take
care to ensure that the ejection chute flap locks the
grass catcher in place.
Illustration G
Installing the battery pack
1. Open the battery flap.
Illustration H
2. Push the battery pack into the mounting on the de-
vice.
3. Insert the safety key.
4. Close the battery flap. Take care to ensure that the
battery flap is latched closed.
English

Installation

Initial startup