Preparations At The Workplace; Adjusting The Guard; Types Of Work; Switching On And Off - Hilti DGH 130 Manual De Instrucciones

5

Preparations at the workplace

CAUTION
Risk of injury! Inadvertent starting of the product.
▶ Unplug the supply cord before making adjustments to the power tool or before changing accessories.
Observe the safety instructions and warnings in this documentation and on the product.
5.1 Installing the accessory tool with the Keyless quick-release lock nut
Use only accessory tools approved for a speed at least equal to the rated speed stated on the device.
1. Switch off the power tool.
2. Unplug the supply cord from the power outlet.
3. Clean the clamping flange and the quick-release lock nut.
4. Fit the clamping flange to the arbor.
5. Fit the accessory tool.
6. Press and hold down the spindle lock button.
7. Screw the Keyless quick-release lock nut down until it is seated on the accessory tool, then tighten it
firmly so that it is secure.
8. Then release the arbor lock button.
5.2 Removing the accessory tool with the Keyless quick-release lock nut
1. Switch off the power tool.
2. Unplug the supply cord from the power outlet.
3. Press and hold down the arbor lockbutton.
4. Release the Keyless quick-release lock nut by turning the quick-release lock nut counter-clockwise by
hand.
5. Release the arbor lockbutton and remove the accessory tool.
5.3

Adjusting the guard

1. Switch off the power tool.
2. Position the power tool on the grinding disc.
3. Use the height adjuster to adjust the height.
The guard is at the optimum height when the distance between the slats and the surface is
approximately 1 mm.
4. If you are working along a corner, turn the segment opening of the guard to the desired position.
5. Be sure to close the segment opening when you finish working along the corner.
6

Types of work

6.1

Switching on and off

6.1.1 Switching on
1. Plug the supply cord into the power outlet.
2. Press the rear section of the on/off switch.
3. Slide the on/off switch forward.
4. Lock the on/off switch.
➥ The motor runs.
6.1.2 Switching off
▶ Press the rear section of the on/off switch.
➥ The on/off switch jumps into the off position and the motor stops.
*2204296*
Printed: 23.07.2019 | Doc-Nr: PUB / 5504888 / 000 / 00
2204296 English 19