Whirlpool Maytag MVW6200KW Manual Tecnico página 36

A. Tab on Underside of Top Panel
7. Slide the Top Panel forward about 1/2" (13 mm).
8. Raise the Top Panel about 1/4" (6 mm). While keeping it lifted, push the
Top Panel back about 1/4" (6 mm).
9. Tilt the Top Panel up and make sure that the rear tabs slide into the slots
as shown in below figure.
36
FOR SERVICE TECHNICIAN'S USE ONLY
A
Figure B
Removing the Tub Ring
NOTE: Due to the increase in size and depth of the tub ring, the working space
between the tub ring and side panel is very limited.
1. Locate the eight (8) tub ring clips as shown in below figure. Unclip each
clip with a "stubby" flat blade screwdriver.
2. Lift the left-rear suspension rod and disconnect it from the rear brace.
This will allow more room to access the two (2) clips located on both
sides of the bleach well. Remove tub ring from washer.
DO NOT REMOVE OR DESTROY