Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
SAFETY NOTES
The soldering station is only allowed to solder and unsolder the electrics and the electrons in the
printing electrical circuit and the models; tin the circuitry and the lead; connects the lead.
Only use soldering station when the components to be soldered are disconnected from power
supply. Caution when soldering of capacitors. Capacitors must be discharged before soldering.
Do not heat liquids (water, electrolyte, etc.) or heat plastics parts (it will form poisonous air and
cause fires) with soldering station.
Only the voltage and frequency marked on the data plate can be used by the soldering station.
A damaged soldering station is not allowed to be used again, and the power supply must be cut
off, in case that some one who don't know that will use it.
Only be installed soldering station in the dry workshops to operate.
The soldering station in operation must be looked after by workers.
Keep soldering station out of children reach.
Do not use the soldering station under the wet circumstances or near the easily flaming or the
explosive materials or air.
You have to obey the corresponding regulation of safety protection, if the solder is used in the
industry.
If the soldering station is moved from the cold room to the warm room, the temperature will be
changed, which will cause the congealed water which will affect or damage the components of the
machine, please wait to solder until the temperature of the soldering station is the same with that
in the room.
Do not operate the soldering station under high temperature.
The temperature of the electric soldering irons can reach more than 160℃, do not touch the
electric soldering irons, risk of serious burn.
It is totally prohibited to put the electric soldering irons into the water in order to cold it.
Do not cover the fan opening of the soldering station.
Renew a damaged fuse only with a same characterized, it is prohibited to use a other
characterized.
Do not operate the soldering station if it is damage. For e.g. problems at insulations, damaged
housing, etc.
Do not open the soldering station. Maintenance and repair can only be done by trained personal
with strict training. Self-disassembly may result in the danger of electric shock.
APPLICATION
In order to guarantee the user's safety and prevent the soldering station from being damaged, please
obey the safety hints and the warning signs in the operation instructions.
Tin the new soldering mouth when using the machine at first time. To do this, switch on the soldering
station, than thaw a little soldering tin into a thin film which can be affixed on the soldering mouth
when temperature reaches about 200°C.
The key to ensure the quality of soldering point is the proper soldering temperature. The soldering
temperature of electric components is from 300°C to 380°C. Too low temperature will lead to cold
soldering point while too high temperature will result in drop of the soldering preparation and rupture
of the jointing slot. Moreover too high temperature will also possibly lead to damage of circuitry (the
plating layer of the lead) and components. Before soldering, clean the soldering mouth directly with
the sponge so as to clean away the soldering.
SW-Stahl und Werkzeugvertriebs GmbH
L
e
v
e
k r
u
s
r e
t S
a r
s
s
e
6
5
D
4 -
2
8
9
7
R
e
m
s
c
h
e
d i
Tel. +49 (0) 2191 / 46438-0
F
ax +49 (0) 2191 / 46438-40
- E
M
a
: l i
n i
o f
@
s
w
s
a t
l h
d .
e
Publicidad
Tabla de contenido
