Problems - Bosch TCE 422X Manual De Instrucciones

2.

Problems

Anomalies
The head roller is blocked
The head group is too close to the edge of the circle
The rotation of the self-centring is slow or noisy
The invertor pedal does not return
The wedges do not block
The bead-breaking cylinder does not work correctly
There is an air emission from one of the sinks
Robert Bosch GmbH
Problems | TCE 422X | 1�
Causes and possible solutions
The roller is not lubricated or is dirty
Screws to adjust (see chapter "Adjustments")
R The belt is loosen or worn out
R Lack of a phase due to the engine
R Lack of a phase due to the electrical system
R Check the line tension with the machine one
R Defective reducer
R The engine pulley is not correctly assembled
R Controlar que la toma no esté dañada
Substitute the invertor spring
R Check the exercise pressure
R Check the wedges not to be worn out
R Check and clean the tracks
R Check there is no loss on the locking cylinders
R Check the turning collector
R Check on the pedals that:
- The sink is correctly adjusted
- The control pedal is not damaged
- The return spring of the ratchet is not damaged
- The return spring of the pedal is not damaged
- The plastic ratchet is not damaged
R Check the exercise pressure
R Check the return spring positioned on the arm is integral
R Check there is no loss from the cylinder
R Ckeck that the cylinder space is not damaged
R Check that the cylinder head is not damaged
R Check on the pedals that:
- The sink is correctly adjusted
- The control pedal is not damaged
- The return spring of the ratchet is not damaged
R Check that the sink is not damaged
R Check that the emission does not come
from a defective cylinder
R As for the self-centring pedal, also check that
the emission is not caused by the turning
TCE 422X | 1� | 1� en
|
1 695 106 342 2008-10-17