Luminance Brands Kathy Ireland Home CF542ORB00 El Manual Del Propietario página 11

3. Ceiling Fan Assembly
3.15
While pulling up on the 4 .5" Downrod, retighten the Two
Set Screws (previously loosened) in the Motor Coupler
to secure the Downrod into place (Figure 15) .
NOTE: The set screws must be properly installed as
described above, or fan wobble could result.
WARNING
!
It is critical that the set screws in the motor coupler are
properly installed and securely tightened. Failure to
verify that the set screws are properly installed could
result in the fan falling.
3.16
Make sure the Grommet is properly installed in the
Motor Coupler Cover then slide the Motor Coupler
Cover on the Downrod until it rests on the Motor
Housing .
Be sure the Motor Coupler Cover is oriented correctly
(Figure 16) .
3.17
Place the Ceiling Cover over the Downrod .
Be sure the Ceiling Cover is oriented correctly
(Figure 17) .
(continued)
RETIGHTEN TWO
PHILLIPS HEAD
SET SCREWS
Figure 15
Figure 16
Figure 17
Please contact 1-800-777-4440 for further assistance
11
MOTOR
COUPLER
DOWNROD
GROMMET
COUPLER
COVER
CEILING
COVER
DOWNROD
luminancebrands.com
U.L. Model No.: CF542 & CF552