Husqvarna 587960201 El Manual Del Propietario página 6

INSTALLING DRIVE BELT
1. Make sure the tension release lever is forward or
disengaged.
2. Place the belt over the pulley on the deck. Refer to
illustration for proper routing.
3. Move the tension release arm to the rear and
engage in the latch.
Tension Release Arm
Rear of Deck
INSTALLING BELT COVERS
1. Place the deck belt shield on the deck over the
drive pulley and secure with hardware removed
from steel belt shield.
2. Place retainer on the outer pulley cover.
3. Align the tab end of the belt cover into the slot on
the deck belt shield and the other end over the end
of the outer pulley cover.
4. Secure with knob.
Belt Cover Tab
Deck Belt
Middle Chute Latch
Shield
Outer Pulley Cover
6
ASSEMBLY
Outer Pulley
Twist in Belt
Idler Pulleys
Knob
Retainer
INSTALLING MIDDLE CHUTE
1. Using the hacksaw, trim along the dashed line.
2. Place middle chute over the top end of the blower
assembly.
3. Latch middle chute to blower assembly.
Trim Line
Blower Assembly