Electrical Installation With Solar Power - COPELE EQUIMATIC Manual De Instrucciones

6.2. Electrical installation with solar power.

The machine can be supplied without the battery. If this is the case, a pair of clamps will be
provided for direct connection to the power input of the machine.
Clamps are connected to the terminals of an external 12 VDC battery which is charged with a
solar power installation. Clamps are the same that were shown in the previous section.
The polarity of the battery must be observed at all times; otherwise, the dosing mechanism
would break down.
THE ELECTRICAL INSTALLATION CAN ONLY BE OPERATED AND/OR
REPAIRED BY QUALIFIED TECHNICIANS.
INSTRUCTION MANUAL
ELECTRICAL
INSTALLATION
Page 15 of 29