Working Instructions - Bosch GHO 10-82 Professional Manual Original

OBJ_BUCH-447-001.book Page 40 Monday, October 8, 2007 11:18 AM
40 | English
Starting Operation
Observe correct mains voltage! The voltage
of the power source must agree with the
voltage specified on the type plate of the
power tool.
Switching On and Off
To start the power tool, press the On/Off switch
5 and keep it pressed.
To lock the pressed On/Off switch 5, press the
lock-on button 4.
To switch off the power tool, release the On/Off
switch 5 or when it is locked with the lock-on but-
ton 4, briefly press the On/Off switch 5 and then
release it.
0 601 594 037:
To start the power tool, first push the lock-off
button for the On/Off switch 4 and then press
the On/Off switch 5 and keep it pressed.
To switch off the power tool, release the On/Off
switch 5.
Note: For safety reasons, the On/Off switch 5
cannot be locked on but must remain pressed
during operation.

Working Instructions

Planing (see figure N)
Set the required planing depth and place the
front part of the planer base plate 8 against the
workpiece.
Apply the power tool to the workpiece only
when switched on. Otherwise there is danger
of kickback when the cutting tool jams in the
workpiece.
Switch the machine on and guide the machine
with even feed over the surface to be planed.
To achieve high-grade surfaces, work only with
low feed and apply pressure on the center of the
planer base plate.
When machining hard materials (e. g. hardwood)
as well as when utilizing the maximum planer
width, set only low planing depths and reduce
the planer feed, as required.
1 609 929 M02 | (8.10.07)
Excessive feed reduces the surface quality and
can lead to rapid clogging of the chip ejector.
Only sharp blades achieve good cutting capacity
and give the machine longer life.
The integrated park rest 29 also allows for con-
tinued planing at any given location on the work-
piece after an interruption:
– With the park rest folded down, place the ma-
chine on the location of the workpiece where
the planing is to be continued.
– Switch on the machine.
– Apply the supporting pressure onto the front
part of the planer base plate and slowly push
the machine forward ( ). This tilts the park rest
upward ( ) so that the rear part of the planer
base plate faces on the workpiece again.
– Guide the machine over the surface to be
planed ( ) with even feed.
Beveling Edges (see figure O)
The V-grooves in the front planer base plate allow
quick and easy beveling of workpiece edges. De-
pending on required bevel width, use the corre-
sponding V-groove. For this, place the planer
with the V-groove onto the edge of the workpiece
and guide it along the edge.
Groove to be
used
none
small
medium
large
Planing with Parallel/Beveling Guide
(see figures K–M)
Mount the parallel guide 21 or beveling guide 25
to the machine using the corresponding fasten-
ing bolt 24. Depending on the application, mount
the rebating depth stop 28 with fastening bolt 27
to the machine.
Loosen the locking nut 23 and adjust the request-
ed rebating width on the scale 22. Tighten the
locking nut 23 again.
Adjust the requested rebating depth accordingly
with the rebating depth stop 28.
Dimension a
(mm)
0 – 4
2 – 6
4 – 9
6 – 10
Bosch Power Tools