Dash Disassembly - Metra 99-9229G Instrucciones De Instalación

1. Remove the panel between the
climate control and gear selector.
(Figure A)
2. Move the gear selector as far back
as possible, unsnap the panel
surrounding it, and then rotate it
45 degrees either way. (Figure B)
3. Remove (2) T-25 screws now
exposed securing the climate
control panel to the vehicle, and
then remove. (Figure C)
Continue to 3 a.
(Figure A)

Dash Disassembly

(Figure B)
(Figure C)
(Figure D)
99-9229G
a. Angle the panel outwards so
that it is possible to insert a
couple of fingers between the
center console and the side of
the panel. (Figure D)
b. Remove the panel by pulling
it downward, maintaining the
same angle. Some force is
required because the panel is
tightly installed. (Figure D)
c. Do not unplug the connectors.
Place the panel to one side instead .
4. Remove (2) T-25 Torx screws
securing the radio, and then
remove. (Figure E)
5. Remove the sub-dash bracket from
the radio, and then remove.
a. Remove (5) T-25 Torx screws
securing the bracket. (Figure F)
b. Depress the snaps on the top
and bottom of the pocket.
(Figure G)
Continue to kit assembly
2
(Figure E)
(Figure F)
(Figure G)