Table of Contents
Table of Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Pre-Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Tools Required . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Package Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Safety Information
WARNING: Carefully read and understand the
information given in this manual before beginning the
assembly and installation . Failure to do so so could lead to
electric shock, fire, or other injuries which could be hazardous
or even fatal .
WARNING: Ensure the electricity to the wires you are
working on is shut off . Either remove the fuse or turn off the
circuit breaker
.
WARNING: Risk of fi re or electric shock . Installation of this
LED Retrofit Kit assembly requires a person familiar with the
construction and operation of the light fixture's/luminaire's
electrical system and the hazard involved . If not quali fied, do
not attempt installation . Contact a qualifi ed electrician .
WARNING: Install this kit only in luminaires (light fixtures)
that have the construction features and dimensions shown in
the photographs and/or drawings included in these installation
instructions, and where the input rating of the retrofi t kit does
not exceed the input rating of the luminaire .
WARNING: Do not make or alter any open holes in an
enclosure of wiring or electrical components during kit
installation .
WARNING: To prevent wiring damage or abrasion, do not
expose wiring to edges of sheet metal or other sharp objects .
Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Care and Cleaning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
NOTICE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules .
These limits are designed to provide reasonable protection against
harmful interference in a residential installation .
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications . However, there is
no guarantee that interference will not occur in a particular installation .
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
□ Reorient or relocate the receiving antenna .
□ Increase the separation between the equipment and the receiver .
□ Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected .
□ Consult the dealer or an experienced radio/TV technician for help .
WARNING: Changes or modifications not expressly approved
by the party responsible for compliance could void the user's
authority to operate the equipment .
NOTICE: Minimum lamp compartment dimensions for Model # 53193101,
53193111, and 53193141: 5 inch diameter x 7 .5 inch height when used in a
5 in . recessed luminaire . 6 inch diameter x 7 .5 inch height when used in 6
in . recessed luminaire .
NOTICE: Minimum lamp compartment dimensions for Model # 53182201
and 53182211: 4 inch diameter x 7 .5 inch height when used in a 4 in .
recessed luminaire .
1