Installation; Mount To 5 In./6In. Housing With C-Clamps; Turning Off The Power - ETI 53182201 Manual De Uso Y Cuidado

Installation

Before beginning assembly, installation or operation of product, make sure all parts are present . Compare parts with the package contents
list . If any part is missing or damaged, do not attempt to assemble, install or operate the product . Contact customer service for replacement
parts .
Part # DL-6-11-827-SV-D / Model # 53193101, Part # DL-6-11-830-SV-D / Model # 53193111, Part # DL-6-11-840-SV-D / Model # 53193141
can be installed into 5 in . and 6 in . housings .
NOTE: Product is shipped in the 6 in . position . If installing in a 6 in . housing with C-Clamps, no adjustments are necessary .
However, if installing in a 6 in . housing without C-Clamps or in a 5 in . housing, the appropriate instructions must be followed .
Part # DL-4-10-827-SV-D / Model # 53182201, Part # DL-4-10-830-SV-D / Model # 53182211 should be installed in 4 in . housings only .

Mount to 5 in./6in. Housing with C-Clamps

Part # DL-6-11-827-SV-D / Model # 53193101, Part # DL-6-11-830-SV-D / Model # 53193111, Part # DL-6-11-840-SV-D / Model #
53193141 can be installed into 5 in . and 6 in . housings .
1

Turning off the power

□ Make sure the power is turned off at the source to the
recessed can housing where the fixture will be installed .
□ Remove the existing bulb and trim, revealing the socket .
NOTICE: Stick the replacement label on
the inner wall of the recessed housing before
installation .
C-Clamps
2
Adjusting the spring clips
The factory setting of the spring clips is for 6 in . recessed can
housings . To install in 5 in . recessed can housings:
□ Loosen the two screws in the brackets holding the spring
clips on both sides of the LED light module using a Phillips
screwdriver (not included) .
□ Slide the brackets holding the spring clips inward until the
screws are in the 5 in . position, then tighten the screws
using a Phillips screwdriver (not included) .
Bracket
screw
3
Bracket
Spring
Clip