brennenstuhl EL 2000 MA Manual De Instrucciones página 7

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 21
EL 2000 MA
CONTROL ELEMENTS
A Switch
B USB output (power bank)
C Battery status indicator
D Button
E Charging input
F Tripod fastening
COMMISSIONING
Place the light on a dry and level surface.
Use the switch (A) on the back side to switch
the light on.
Press the switch multiple times to set the
brightness to 100%, then 50% and then "off".
The lower the brightness selected, the longer
the light will burn.
BATTERY STATUS INDICATOR
The battery status indicator (C) appears automatically when the light is switched on. It can
moreover be activated by pushing the button (D) below the battery indicator.
If all 4 LEDs are lit, the battery is fully charged.
If the battery is almost empty, the light flashes 5 times and the battery status indicator flashes
continuously. Afterwards, the light will remain on for approx. 5 minutes before the light is
switched off by the deep discharge protection function.
This ensures sufficient time to complete the work.
CHARGING THE BATTERY
To ensure optimum functionality, we recommend fully discharging the battery on the first use
and fully charging it afterwards.
1. The charging input (E) is located under the cover cap on the back side of the light.
2. The charging status of the battery is indicated by the battery status indicator (see description
above).
3. If the device is not used for longer periods of time, charge the battery at regular intervals of
approx. 3 months to ensure a long service life.
4. The product may be used during charging. In this operating mode, the battery charging time
will be considerably extended.
5. After charging, always close the charging port with the cover cap.
CHARGING EXTERNAL DEVICES VIA USB
The light offers a USB power bank function. An external device like a smartphone or tablet can be
connected to the USB port (B) and charged. The number of possible charging cycles depends on
the type of external device and on the charging level of the light's battery.
TRIPOD MOUNTING
By means of the holes in the holding bracket (F in the figure), the light can be mounted on a
Brennenstuhl tripod (fastening material not included in the scope of delivery).
20P158 Mobiler LED Akku Strahler EL 2000 MA 0533090 210305.indd 7
20P158 Mobiler LED Akku Strahler EL 2000 MA 0533090 210305.indd 7
Operating instructions
A
B
C
D
E
F
7 7
05.03.2021 11:52:10
05.03.2021 11:52:10

Publicidad

Tabla de contenido
loading

Tabla de contenido