Harman JBL 4367 El Manual Del Propietario página 5

Using Spade Connectors:
A. Unscrew Cap
IMPORTANT: Make sure the (+) and (–) spade connector blades do not touch each other or the other terminal.
Touching blades can cause a short circuit that can damage your receiver or amplifier.
Using Banana Connectors:
A. Tighten Cap
BI-WIRE CONNECTION:
The 4367 connection assembly has two sets of input terminals that are connected by jumper wires. The upper set of
terminals is for high-frequency/ultrahigh-frequency drivers, and the lower set of terminals is for the woofer.
This arrangement allows you to bi-wire the speakers using a single stereo power amplifier or two stereo power
amplifiers. Bi-wiring can offer sonic advantages and more flexibility in power-amplifier selection over a conventional
single-wire connection.
To bi-wire the 4367, first remove the terminal jumper wires as shown in the illustration.
Remove Caps
If you're bi-wiring with a single stereo power amplifier, connect the speakers according to the following illustration.
Left Speaker
Midrange/
Tweeter
Connection
Woofer
Connection
B. Insert Spade Connector C. Tighten Cap
Blades around Post
B. Insert Banana Connector into
Hole in Cap
Remove Jumpers from Posts
Amplifier
Replace Caps
Right Speaker
Midrange/
Tweeter
Connection
Woofer
Connection
www.jbl.com
5