Dts Cooling Unit Assembly (Side Attachment) - Pfannenberg DTS Serie Manual De Instrucciones

ENG
4.5.2

DTS cooling unit assembly (side attachment)

4.5.2.1 Making cut-outs for DTS cooling unit
Assembly holes
Fig. 9: External view of switch cabinet, assembly bores and cut-outs
1 Holes
2 Device contour
Requirements
DANGER – Danger to life due to electric shock. Make sure that the unit is voltage-free.
•
All general requirements are satisfied, see "General", Page 25.
Required tools and materials
•
Saw
•
Switch cabinet milling machine if necessary
•
Protective covers
Procedure
1. Ensure that the switch cabinet has a protective cover to protect against chips.
2. Make cut-outs and assembly holes as shown in Fig. 9.
3. Deburr the cutting edges.
4. Remove chips and assembly waste from the switch cabinet.

The cut-outs and holes are made and the cooling unit can be assembled.
Operating Manual | Attachment and Installation Cooling Units | Standard Controller (SC) – 230 V | 086100001e
Assembly cut-outs
3 Assembly cut-outs
26/58