Table of Contents
Warranty ...................................................2
Safety Information
PRECAUTIONS
□
Please read and understand this entire manual
before attempting to assemble, install, or operate
this light fixture.
□
This light fixture requires a 120-Volt AC power
source.
□
Some codes require installation by a qualified
electrician.
□
This light fixture must be properly grounded.
□
This light fixture should be installed outdoors to a
wall or eave.
□
The light fixture should be mounted approximately
8 ft. (2.4 m) above the ground. If the light fixture
is mounted higher than recommended, aiming the
sensor down will reduce the coverage area.
Warranty
5-YEAR LIMITED WARRANTY
WHAT IS COVERED
This product is guaranteed to be free of factory defective parts and workmanship for a period of 5 years from date
of purchase. Purchase receipt is required for all warranty claims.
WHAT IS NOT COVERED
This guarantee does not include repair service, adjustment and calibration due to misuse, abuse or negligence, or
LEDs. Any damage to the light fixture resulting from the use of chemicals or a pressure washer machine are not
covered by this warranty. Unauthorized service or modification of the product or of any furnished component will
void this warranty in its entirety. This warranty does not include reimbursement for inconvenience, installation,
setup time, loss of use, unauthorized service, or return shipping charges. This warranty is not extended to other
equipment and components that a customer uses in conjunction with this product.
No service parts available for this product.
Contact the Customer Service Team at 1-866-308-3976 or visit www.homedepot.com.
Installation ................................................5
Operation...................................................8
WARNING: Turn the power off at the circuit breaker or
fuse. Place tape over the circuit breaker switch and verify
power is off at the light fixture.
CAUTION: To avoid water damage and the risk of
electrical shock, the motion sensor controls must be facing
the ground when the installation is complete.
CAUTION: Burn hazard. Allow the light fixture to cool
before touching.
NOTICE: Do not connect this light fixture to a dimmer switch or
timer.
2