Care And Cleaning; Troubleshooting - Defiant DF-5909-WH Guía Para El Uso Y Cuidado

Luz de seguridad por movimiento
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Care and Cleaning

To prolong the original appearance, clean the light fixture with clear water and a soft, damp cloth only.
Do not use paints, solvents, or other chemicals on this light fixture. They could cause a premature
deterioration of the finish. This is not a defect in the finish and will not be covered by the warranty.
Do not spray the light fixture with a hose or power washer.

Troubleshooting

Problem
The light will not come
on.
The light comes on
during the day.
The light comes on for
no apparent reason.
Possible Cause
The motion sensor is not angled
correctly.
The light switch is turned off.
The fuse is blown or the circuit breaker
is turned off.
The light fixture is not properly
attached to the mounting plate, if this is
a new installation.
The ON-TIME switch is set to 5 or 20
so the daylight turn-off (photocell) is
in effect.
The circuit wiring is incorrect (if this is
a new installation).
The motion sensor is aimed in the
wrong direction.
The outside air temperature is close to
the same as a person's body heat.
The motion sensor may be installed in a
relatively dark location.
The "ON-TIME" setting is set to "TEST".
The motion sensor may be sensing
small animals or automobile traffic.
The "SENS" setting is set too high.
The "DUALBRITE" setting is in the 5
hour or D2D (dusk-to-dawn) setting.
The outside temperature is much
warmer or cooler than a person's body
heat (summer or winter).
The light fixture is wired through a
dimmer or timer.
Solution
Rotate the motion sensor correctly
(see step 2 under Operation).
Turn the light switch on.
Replace the fuse or turn the circuit
breaker on.
Re-install the light fixture to the
mounting plate (see steps 5 and 6
under Installation).
Recheck after dark or use the TEST
feature (see steps 3 and 4 under
Operation).
Verify the wiring is correct (see steps
2 and 3 under Installation).
Re-aim the motion sensor to cover
the desired area.
Increase the "SENS" setting.
The light fixture is operating normally
under these circumstances.
Set the "ON-TIME" setting to the 5 or
20 minute setting.
Decrease the "SENS" setting or
reposition the motion sensor.
Decrease the "SENS" setting.
The light fixture is operating normally
under these circumstances. Set
"DUALBRITE" to OFF if no accent
lighting is desired.
Decrease the "SENS" setting.
Do not use a dimmer or timer to
control the light fixture. Replace the
dimmer or timer with a standard on/
off wall switch.
11
Please contact 1-866-308-3976 for further assistance.
HOMEDEPOT.COM

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

1004365415

Tabla de contenido