Operation - Defiant DF-5909-WH Guía Para El Uso Y Cuidado

Installation (continued)
7
Caulking around the light
fixture
CAUTION: Failure to completely caulk around the light
fixture's mounting plate could result in water seepage into
the junction box.
□
Caulk around the mounting plate (D) and
mounting surface with silicone sealant (not
included).

Operation

1
Adjusting the light panels
CAUTION: Heat sinks can be warm to the touch. Turn
light fixture off for 5 minutes before touching heat sinks.
□
Turn the power on at the circuit breaker or
fuse and turn on the wall switch. The motion
sensor (C) will need to completely warm up (60
seconds) before beginning the setup process.
□
If needed, gently grasp the top and bottom of
the light panels (A) and tilt them up or down or
side to side to adjust the light coverage area.
2
Rotating the sensor controls
downward
This motion sensor (C) has a built-in detection system
to help ensure the sensor (C) is adjusted correctly. If
the motion sensor (C) is angled incorrectly, all of the
control lights on the bottom of the sensor (C) will come
on and the light panels (A) will turn off. The light will
stay off until the motion sensor (C) has been adjusted
correctly.
□
Rotate the motion sensor (C) so the controls
face toward the ground.
NOTE: If the motion sensor is NOT positioned correctly, all
of the control lights will be glowing (shown).
A
A
C
DUALBRITE
8
D
C
DUALBRITE SENS ON TIME
SENS ON TIME