ISOFIX VOLTA 360 ST-3 Manual De Uso página 18

5. INSTALLATION
3. Pull the diagonal belt strongly to tighten (hold
tension) and clamp the lock-off device on diagonal
belt as close to vehicle seat belt buckle as possible
(fig. 43).
4. Seat back then through upper belt guide which in
the same side of vehicle seat belt retractor. (fig.
44).
CAUTION
Make sure belt is not twisted and buckle is
engaged.
5. Shake the child safety seat to make sure it firmly
installed in the vehicle. (fig. 45).
6 . Place the infant cushion on the seat. Have your
child sit down in the child seat. Adjust headrest
in proper height (see section 4.3), adjust harness
and lock buckle (see section 4.1), and tighten
harness. (see section 4.2) (fig. 46).
FOR THE SAFETY OF YOUR CHILD, BEFORE EVERY
JOURNEY IN THE CAR CHECK :
- the child seat is firmly installed in the vehicle;
- the straps of the child safety seat are close to the body
without constricting the child.
- the shoulder belts are correctly adjusted and the straps
are not twisted.
- the shoulder pads are at the same level as your child's
shoulders.
- the buckle latches are engaged in the harness buckle .
5.2 GROUP 1 FORWARD FACING
from 9 months to 4 years)
IMPORTANT
DO NOT use forward facing before the child's
weight exceeds 9 kg
once the car seat is installed, if another
WARNING!
recline position is selected, you should repeat the car
seat installation steps described below to ensure a
proper installation in this new position.
34
1
(9-18kg, approx.
5. INSTALLATION
1. Rotate seat to forward facing
(see section 4.5). Place seat
43 43
in the direction facing to the
travel. (fig. 47, 48).
2. Install ISOFIX connectors
(see section
49) (If your seat don't
2 equipped ISOFIX or your
car don't equipped ISOFIX
anchorage, please install
only use 3-point belt).
44 44
3. Pull the Vehicle belt out
and guide it pass through
the belt pass slot of the
child seat. (fig. 50) Make
sure that the belt is not
twisted.
4. Engage the buckle tongue in
the vehicle seat buckle this
should make a click noise.
(fig. 51)
45
CAUTION
The vehicle seat belt buckle
must not be positioned in the
belt pass slot.
5. Pull the
strongly to tighten (hold
tension) and clamp the lock-
46
off device on diagonal belt
as close to vehicle seat belt
buckle as possible (fig. 52).
CAUTION
Make sure belt is not twisted
and buckle is engaged.
6. Shake the child safety
seat to make sure it firmly
installed in the vehicle. (fig.
53).
4.6) (fig.
CLICK
diagonal belt
47 48
49 50
51 52
53
35