PULOX PO-650B Manual De Instrucciones página 24

1.3 Attention
 Keep the device away from dust, vibration, corrosive substances,
explosive materials, high temperature and moisture.
 If the oximeter gets wet, please stop operating it.
 When it is carried from cold environment to warm or humid
environment, please do not use it immediately.
 DO NOT operate keys on front panel with sharp materials.
 High temperature or high pressure steam disinfection of the
device is not permitted. Refer to User Manual in the relative
chapter (7.1) for instructions of cleaning and disinfection.
 Do not have the device immerged in liquid. When it needs
cleaning, please wipe its surface with medical alcohol by soft
material. Do not spray any liquid on the device directly.
 When cleaning the device with water, the temperature should be
lower than 60°C.
 The fingers which are too thin or too cold may affect the normal
measure of the patients' SpO2 and pulse rate, please clip the thick
finger such as thumb and middle finger deeply enough into the
probe.
 The device can be used to adult or infant. Whether the device is
used to adult or infant, it depends on the probe selected.
 The update period of data is less than 5 seconds, which is
changeable according to different individual pulse rate.
 Please read the measured value when the waveform on screen is
equably and steady-going. This measured value is optimal value,
and the waveform at the moment is the standard one.
 If some abnormal conditions appear on the screen during test
process, pull out the finger and reinsert to restore normal use.
 The device has normal useful life for three years since the first
electrified use.
 This device has the function of alarming, users can check on this
function according to chapter 6.1 as a reference.
 The device has the function of limits alarming, when the
measured data is beyond the highest or lowest limit, the device
would start alarming automatically if the alarming function is on.
 The device has the function of alarming, this function can either
be paused, or closed (default setting) for good. Please check the
chapter 6.1 as a reference.
 The device may not work for all patients. If you are unable to
achieve stable readings, discontinue use.
EN