Maintenance, Transportation And Storage; Troubleshooting - PULOX PO-650B Manual De Instrucciones

bleeding, or use of vascular contracting drug, the SpO2 waveform
(PLETH) will decrease. In this case, the measure will be more
sensitive to interference.
B. For those with a substantial amount of staining dilution drug
(such as methylene blue, indigo green and acid indigo blue), or
carbon monoxide hemoglobin (COHb), or methionine (Me+Hb) or
thiosalicylic hemoglobin, and some with icterus problem, the
SpO2 determination by this device may be inaccurate.
C. The drugs like dopamine, procaine, prilocaine, lidocaine and
butacaine may also be a major factor resulted in serious error of
SpO2 measure.
D. As the SpO2 value serves as a reference value for judgment of
anemic anoxia and toxic anoxia, some patients with serious
anemia may also report good SpO2 measure.

7. Maintenance, Transportation and Storage

7.1 Cleaning and Disinfecting
Using medical alcohol to disinfect the device, nature dry or clean it
with clean soft cloth.
7.2 Maintenance
A. Please clean and disinfect the device before using according to
the User Manual (7.1).
B. Please change the battery when the screen shows low power
alarm information.
C. Take out the battery if the oximeter is not in use for a long time.
7.3 Transportation and Storage
A. The packed device can be transported by ordinary conveyance or
according to transport contract. The device can not be
transported mixed with toxic, harmful, corrosive material.
B. The packed device should be stored in room with no corrosive
gases and good ventilation. Temperature: -40°C~60°C; Humidity:
≤95%

8. Troubleshooting

Trouble
The SpO2 and
Pulse Rate can not
be displayed
normally
Possible Reason
1. The finger is not
properly positioned
2. The patient's
SpO2 is too low to
be detected.
Solution
1. Place the finger
properly and try
again.
2. Try again; Go to
a hospital for a
diagnosis if you are
EN